Dell Inspiron 1210 서비스 매뉴얼 - 페이지 24

{카테고리_이름} Dell Inspiron 1210에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 1210 39 페이지. Service manual
Dell Inspiron 1210에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (19 페이지)

페이지 인쇄
Dell Inspiron 1210 서비스 매뉴얼
Back to Contents Page
  Memory Module
Dell™ Inspiron™ 1210 Service Manual 
  Removing the Memory Module(s)
  Replacing the Memory Module(s)
 
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions shipped with your computer.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup Guide for information on the
memory supported by your computer. Install only memory modules that are intended for your computer.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
Your computer has two user-accessible SODIMM sockets that can be accessed from the bottom of the computer.
NOTICE:
If you need to install memory modules in both connectors, first install a memory module in the connector located at the bottom of the
computer (DIMM 1) before you install a module in the connector directly above it (DIMM 2).
 Removing the Memory Module(s)
NOTICE:
If a memory module is installed in the DIMM 2 connector, remove it prior to removing the memory module from the DIMM 1 connector. Failure to
do so could result in damaging both memory modules.
 
1. Follow the procedures in
Before You
 
2. Remove the module cover (see Base Cover).
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
 
3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
 
4. Remove the module from the connector.
1
memory module connector
3
memory module
 Replacing the Memory Module(s)
 
1. Align the notch in the module edge connector with the tab in the connector slot.
 
2. Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If the module does not click into place,
remove the module and reinstall it.
NOTE:
If the memory module is not installed properly, the computer may not boot.
Begin.
2
securing clips (2)