Avtech AVD717ZC 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Avtech AVD717ZC에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtech AVD717ZC 16 페이지. High-end series

3.3 External Device Connections (Optional)

This optional peripheral (VGA Converter) allows your DVR to have VGA output function. For the connection method,

please refer to the following figure:

For the connected IDA to be correctly detected by your DVR, please don't install HDD in the "HDD3" position (For

connection details, please refer to "3.1 Install HDD" at page 2).

1) Install HDDs:

Install HDDs in the IDA. Please set the HDD as "Master" mode (do not use "Slave" mode). After all HDDs are installed,

please lock the HDD tray by using the HDD key supplied in the IDA package.

2) Connect all IDA with SCSI cable (IDE interface):

Connect from one of the three "DEVICE PORT" at one IDA rear panel to the host port of another disk array.

One IDA (as the master layer) can connect up to 3 IDA as the second layer, and each IDA in the second layer can

respectively connect up to 3 IDA as the third layer. Please refer to the illustration below for details.

Note: In order to accurately detect all the connected disk arrays, please make sure to turn on the power of

all the disk arrays after the connection is completed. The maximum layer number is 3, totally 13 IDA.

3) Connect the master IDA to your DVR with a SCSI Cable (IDE interface):

Connect the host port of the master IDA to the "DISK ARRAY" port of your DVR. Please refer to the illustration below.

Page 4

QUICK INSTALLATION