Avtech AVD717ZD 빠른 시작 매뉴얼 - 페이지 14
{카테고리_이름} Avtech AVD717ZD에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtech AVD717ZD 16 페이지. High-end series
페이지 인쇄
5. PIN CONFIGURATION
When the magnetic contact is opened, the alarm will be triggered and the recording is on. At the same time, COM
connects with NO and the siren with strobe starts wailing and flashing.
NOTE: Please go to MENU -> ADVANCE -> DETECTION -> DETECTION SETUP, and set ALARM to LOW on the
local machine.
PIN
FUNCTION
GND
1
ALARM INPUT
2~9
PIN OFF
10
11
TXD232
12
RS485-A
EXTERNAL
13
ALARM NO.
PIN OFF
14
15~22
ALARM INPUT
23
RXD232
24
RS485-B
EXTERNAL
25
ALARM COM
GROUND
When connecting the wire from ALARM INPUT (PIN 2 -- 9) to GND (PIN 1) connector, DVR
will start recording and the buzzer will be on.
Using RS-232 serial communication signals, DVR can be controlled remotely by the
keyboard of PC
Using RS-485 serial communication signals, DVR can be controlled remotely by the
keyboard of PC
Under the normal operation, COM disconnects with NO. But when any alarm is triggered,
COM connects with NO.
Attention: The voltage restriction is under DC24V 1A.
When connecting the wire from ALARM INPUT (PIN 15 -- 22) to GND (PIN 1) connector,
DVR will start recording and the buzzer will be on.
Using RS-232 serial communication signals, DVR can be controlled remotely by the
keyboard of PC
Using RS-485 serial communication signals, DVR can be controlled remotely by the
keyboard of PC
Under the normal operation, COM disconnects with NO. But when any alarm is triggered,
COM connects with NO.
Attention: The voltage restriction is under DC24V 1A.
Page 13
DESCRIPTION