Dell Inspiron 1420 서비스 매뉴얼 - 페이지 10

{카테고리_이름} Dell Inspiron 1420에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 1420 46 페이지. Service manual
Dell Inspiron 1420에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지), 설정 (2 페이지), 서비스 매뉴얼 (46 페이지)

페이지 인쇄

microprocessor module

NOTICE:

When removing the microprocessor module, pull the module straight up and out of the ZIF-socket. Exercise care not to bend the pins on

the microprocessor module.

NOTE:

The microprocessor module and the ZIF-socket illustration shown may not exactly resemble the ones in your system.

5. Lift the microprocessor module straight up and out of the ZIF-socket.

Replacing the Microprocessor Module

CAUTION:

Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface, such as the back panel on the computer.

NOTE:

When installing a new microprocessor module, use the thermal cooling assembly or thermal pad that came with the module, if applicable.

1. Follow the instructions in

Before You

NOTICE:

Handle the microprocessor module with care. Hold the microprocessor module by its edges and do not touch the processor die (the small

chip in the center of the module).

2. Follow the instructions in

Removing the Microprocessor

NOTICE:

Ensure that the cam lock is in the fully open position before seating the microprocessor module. Seating the microprocessor module

properly in the ZIF socket does not require force. A microprocessor module that is not properly seated can result in an intermittent connection or

permanent damage to the microprocessor and ZIF socket.

3. Align the pin-1 corner of the new microprocessor module with the pin-1 corner of the ZIF socket, and insert the microprocessor module.

NOTE:

The pin-1 corner of the microprocessor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.

NOTE:

Gently press down on the substrate on which the processor die is mounted to ensure the microprocessor module is properly seated.

When the microprocessor module is properly seated, all four corners of the module are aligned at the same height. If one or more corners of the module

is higher than the others, the module is not properly seated.

NOTICE:

To avoid damaging the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor module when turning the

cam screw.

4. To tighten the ZIF-socket cam lock and secure the microprocessor module to the system board, use a small, flat-blade screwdriver and rotate the ZIF-

socket cam screw clockwise until it comes to the cam stop.

5. Replace the microprocessor thermal-cooling assembly (see

ZIF-socket

ZIF-socket cam screw

Begin.

Module.

Replacing the Microprocessor Thermal-Cooling

Assembly).