Dell Inspiron 1440 서비스 매뉴얼 - 페이지 31

{카테고리_이름} Dell Inspiron 1440에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 1440 48 페이지.
Dell Inspiron 1440에 대해서도 마찬가지입니다: 서비스 매뉴얼 (48 페이지)

Back to Contents Page

Wireless Mini-Card

Dell™ Inspiron™ 1440 Service Manual

Removing the Mini-Card

Replacing the Mini-Card

WARNING:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface.

CAUTION:

Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™

is not covered by your warranty.

CAUTION:

To help prevent damage to the system board, remove the main battery (see

computer.

CAUTION:

When the Mini-Card is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge"

in the safety instructions that shipped with your computer).

NOTE:

Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.

If you ordered a wireless Mini-Card with your computer, the card is already installed.

Your computer supports one half Mini-Card slot for Wireless Local Area Network (WLAN).

NOTE:

Depending on the configuration of the computer when it was sold, the Mini-Card slot may or may not have Mini-Card installed in the slot.

Removing the Mini-Card

1. Follow the procedures in

Before You

2. Remove the battery (see

Removing the

3. Remove the module cover (see

4. Disconnect the antenna cables from the Mini-Card.

Mini-Card

antenna cable connectors (2)

5. Remove the screw that secures the Mini-Card to the system board connector.

6. Lift the Mini-Card out of the system board connector.

Begin.

Battery).

Removing the Module

Cover).

screw

Removing the

Battery) before working inside the