Dell Inspiron 1470 서비스 매뉴얼 - 페이지 28

{카테고리_이름} Dell Inspiron 1470에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 1470 46 페이지. Service manual

Back to Contents Page
  Wireless Mini-Card
Dell™ Inspiron™ 1470/1570 Service Manual 
  Removing the Mini-Card
  Replacing the Mini-Card
 
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 
is not covered by your warranty.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
 
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
 
CAUTION:
When the Mini-Card is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge"
in the safety instructions that shipped with your computer).
NOTE:
Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
NOTE:
Depending on the configuration of the computer when it was sold, the Mini-Card slot may or may not have a Mini-Card installed in the slot.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer supports one half Mini-Card slot for Wireless Local Area Network (WLAN).
 Removing the Mini-Card
 
1. Follow the procedures in
Before You
 
2. Remove the battery (see
Removing the
 
3. Remove the module cover (see
 
4. Disconnect the antenna cables from the Mini-Card.
1
Mini-Card
3
antenna cable connectors (2)
 
5. Remove the screw that secures the Mini-Card to the system board.
 
6. Remove the Mini-Card from the system board connector.
 Replacing the Mini-Card
Begin.
Battery).
Removing the Module
Cover).
2
screw
4
system board connector
Removing the
Battery) before working inside the