Dell Inspiron 2100 시스템 참조 매뉴얼 - 페이지 38

{카테고리_이름} Dell Inspiron 2100에 대한 시스템 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 2100 45 페이지. Vga card installation instructions
Dell Inspiron 2100에 대해서도 마찬가지입니다: 여기에서 시작 (2 페이지), 설정 및 기능 정보 (8 페이지), 빠른 참조 매뉴얼 (17 페이지), 서비스 매뉴얼 (38 페이지), 사양 (2 페이지), 설치 지침 (1 페이지)

페이지 인쇄
Dell Inspiron 2100 시스템 참조 매뉴얼
this option are Power On or Stays Off (default).
1st Boot Device Determines which device the computer tries to boot from first. Use the up- or down-arrow key to highlight a device. Settings for
this option are as follows:
Floppy
l
ARMD FDD
l
ARMD HDD
l
IDE-HDD
l
ATAPI CD-ROM
l
SCSI*
l
Network*
l
Disabled
l
*Where SCSI or Network is the name of the installed device.
2nd Boot
Determines which device the computer tries to boot from if it cannot boot from the device selected for 1st Boot Device.
Device
Settings for this option are the same as those for 1st Boot Device except for NETWORK.
3rd Boot
Determines which device the computer tries to boot from if it cannot boot from the devices selected for 1st Boot Device and
Device
2nd Boot Device. Settings for this option are the same as those for 1st Boot Device except for NETWORK and SCSI.
4th Boot Device Determines which device the computer tries to boot from if it cannot boot from the devices selected for 1st Boot Device, 2nd
Boot Device, and 3rd Boot Device. Settings for this option are the same as those for 1st Boot Device except for
NETWORK and SCSI.

Exit Screen

Table 12. Exit Screen Options
Option
Function
Exit Saving
Saves any changes you have made, exits the system setup program, and restarts the computer.
Changes
Exit Discarding
Discards any changes you have made, exits the system setup program, and restarts the computer.
Changes
Load Setup
Discards any changes you have made and reverts all options to their defaults, but does not exit the system setup program.
Defaults
Load Custom
Loads any settings saved using the Save Custom Defaults option. Press <Enter>. Then press the spacebar to select
Defaults
Yes or No at the confirmation pop-up menu, and press <Enter> again.
Save Custom
Saves any changes you have made, but does not exit the system setup program.
Defaults
Discard Changes
Discards any changes you have made and reverts all options to their last saved settings, but does not exit the system
setup program.