Dell Inspiron 518 서비스 매뉴얼 - 페이지 7

{카테고리_이름} Dell Inspiron 518에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 518 38 페이지.
Dell Inspiron 518에 대해서도 마찬가지입니다: 서비스 매뉴얼 (38 페이지)

Back to Contents Page

Replacing the Battery

Dell™ Inspiron™ 518/519 Service Manual

CAUTION:

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION:

manufacturer. Discard used batteries according to the manufacturer's instructions.

1. Record all the screens in system setup (see

2. Follow the procedures in

3. Remove the computer cover (see

4. Locate the battery socket (see

NOTICE:

inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by prying off

the socket or by breaking circuit traces on the system board.

1 battery (positive side) 2 battery release lever

5. Carefully press the battery release lever away from the battery and the battery will pop out.

6. Remove the battery from the system and properly dispose of the battery.

7. Insert the new battery into the socket with the side labeled "+" facing up, then snap the battery into place.

1 battery (positive side) 2 battery release lever

8. Replace the computer cover (see

9. Connect your computer and devices to electrical outlets, and then turn them on.

10. Enter system setup (see

Back to Contents Page

Great user manuals database on

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the

System

Before You

Begin.

Removing the Computer

System Board

Components).

If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the object is

Replacing the Computer

System

Setup) and restore the settings you recorded in

UserManuals.info

Setup) so that you can restore the correct settings in

Cover).

step

10.