Dell Inspiron 580S 서비스 매뉴얼 - 페이지 36

{카테고리_이름} Dell Inspiron 580S에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 580S 43 페이지. Comprehensive specifications
Dell Inspiron 580S에 대해서도 마찬가지입니다: 사양 (6 페이지)

페이지 인쇄
Dell Inspiron 580S 서비스 매뉴얼
 

Changing Boot Sequence for the Current Boot

You can use this feature, for example, to tell the computer to boot from the CD drive so that you can run the Dell Diagnostics on the Drivers and Utilities media,
but you want the computer to boot from the hard drive when the diagnostic tests are complete. You can also use this feature to restart your computer to a
USB device such as a floppy drive, memory key, or CD-RW drive.
 
1. If you are booting to a USB device, connect the USB device to a USB connector.
 
2. Turn on (or restart) your computer.
 
3. When F2 = Setup, F12 = Boot Options appears on the screen, press <F12>.
NOTE:
If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft Windows desktop. Then shut
down your computer and try again.
The Boot Device Menu appears, listing all available boot devices.
 
4. Use the up - or down - arrow keys to select the current boot device and press <Enter>.
For example, if you are booting to a USB memory key, highlight USB Flash Device and press <Enter>.
NOTE:
To boot to a USB device, the device must be bootable. To make sure your device is bootable, check the device documentation.
 

Changing Boot Sequence for Future Boots

 
1. Enter system setup (see
Entering System
 
2. Use the arrow keys to highlight the Boot Device Configuration menu option and press <Enter> to access the menu.
NOTE:
Write down your current boot sequence in case you want to restore it.
 
3. Press the up- and down-arrow keys to move through the list of devices.
 
4. Press plus (+) or minus (–) to change the boot priority of device.
 Clearing Forgotten Passwords
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
1. Follow the procedures in
Before You
 
2. Remove the computer cover (see
 
3. Locate the 3-pin password reset jumper on the system board (see
Setup).
Begin.
Removing the Computer
Cover).
System Board
Components).