Dell Inspiron 8600 서비스 매뉴얼 - 페이지 10
{카테고리_이름} Dell Inspiron 8600에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 8600 46 페이지. Setting up your computer
Dell Inspiron 8600에 대해서도 마찬가지입니다: 서비스 매뉴얼 (42 페이지), 설정 매뉴얼 (2 페이지), 서비스 매뉴얼 (46 페이지)
페이지 인쇄
Back to Contents Page
Microprocessor Module
Dell™ Inspiron™ 8500/8600 Service Manual
Removing the Microprocessor Module
CAUTION:
Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
Do not touch the processor die. Press and hold the microprocessor down on the substrate on which the die is mounted while turning the cam
screw to prevent intermittent contact between the cam screw and microprocessor.
NOTICE:
To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.
1. Follow the instructions in
"Preparing to Work Inside the
2. Remove the keyboard.
3. Remove the fan.
NOTICE:
To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the microprocessor thermal-cooling assembly. The
oils in your skin reduce the heat transfer capability of the thermal pads.
4. Remove the
microprocessor thermal-cooling
NOTICE:
When removing the microprocessor module, pull the module straight up. Be careful not to bend the pins on the microprocessor module.
5. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
1 screwdriver
(perpendicular to
microprocessor)
2 ZIF-socket cam screw
3 ZIF socket
4 pin-1 corner
NOTE:
The ZIF-socket cam screw secures the microprocessor to the system board. Take note of the arrow on the ZIF-socket cam screw, which indicates
the direction to turn the cam screw.
Computer."
assembly.