Dell Inspiron Mini 9 910 서비스 매뉴얼 - 페이지 37

{카테고리_이름} Dell Inspiron Mini 9 910에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron Mini 9 910 39 페이지.

screw (2)

microphone cable connector

8. Disconnect the microphone cable and AC adapter cable from the respective system board connectors.

9. Remove the two screws that secure the system board to the computer base.

10. Lift the system board at an angle towards the side of the computer and out of the computer base.

Replacing the System Board

NOTE:

The thermal pads may stick to the bottom of the palm rest. Remove the thermal pads from the bottom of the palm rest.

1. Remove the centrifugal paper of the thermal pads that shipped with your new system board and paste it on the processor, North Bridge, and South

Bridge.

thermal pad (3)

north bridge

2. Follow all of the steps in

Removing the System Board

NOTICE:

Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in

damage to the computer.

3. Turn on the computer.

NOTE:

After you have replaced the system board, enter the computer Service Tag into the BIOS of the replacement system board.

4. Insert the CD that accompanied the replacement system board into the appropriate drive. Follow the instructions that appear on the screen.

5. The keyboard matrix may change after you replace the system board. To set the keyboard matrix according to your country, see

Matrix.

Setting the Keyboard Matrix

1. Turn off your computer (see

2. If your computer is connected to the AC adapter, disconnect the AC adapter from the computer.

3. Press and hold the following key combination for the desired keyboard matrix:-

United States: <Fn><S>

United Kingdom: <Fn><K>

Japan: <Fn><J>

system board

AC adapter cable connector

south bridge

processor

in reverse order.

Turning Off Your

Computer).

Setting the Keyboard