Dell Inspiron N4030 서비스 매뉴얼 - 페이지 13
{카테고리_이름} Dell Inspiron N4030에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron N4030 48 페이지. Service manual
Dell Inspiron N4030에 대해서도 마찬가지입니다: 서비스 매뉴얼 (48 페이지)
페이지 인쇄
Back to Contents Page
Processor Module
Dell™ Inspiron™ N4020/N4030 Service Manual
Removing the Processor Module
Replacing the Processor Module
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To prevent intermittent contact between the ZIF-socket cam screw and the processor module when removing or replacing the
processor, press to apply slight pressure to the center of the processor module while turning the cam screw.
CAUTION:
To avoid damage to the processor module, hold the screwdriver so that it is perpendicular to the processor module when turning the
cam screw.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Processor Module
1. Follow the instructions in
Before You
2. Remove the thermal cooling assembly (see
3. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
1
ZIF socket
2
ZIF-socket cam screw
CAUTION:
To ensure maximum cooling for the processor module, do not touch the heat transfer areas on the processor thermal-cooling assembly.
The oils in your skin can reduce the heat transfer capability of the thermal pads.
CAUTION:
When removing the processor module, lift the module straight up. Be careful not to bend the pins on the processor module.
4. Lift the processor module from the ZIF socket.
Replacing the Processor Module
Begin.
Removing the Thermal Cooling
Removing the
Battery) before working inside the
Assembly).