2Wire HomePortal 설치 및 지원 매뉴얼 - 페이지 14
{카테고리_이름} 2Wire HomePortal에 대한 설치 및 지원 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2Wire HomePortal 15 페이지.
페이지 인쇄
Regulatory Information
Declaration of Conformity
Trade Name:
Responsible Party:
Address:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly approved in this manual could void your
authority to operate this equipment.
Only peripherals (computer input/output devices, terminals, printers, and so forth) that comply with FCC Class
B limits may be attached to this computer product.
Operation with noncompliant peripherals is likely to result in interference to radio and television reception.
All cables used to connect peripherals must be shielded and grounded. Operation with cables, connected to
peripherals, that are not shielded and grounded may result in interference to radio and television reception.
WARNING:
While this device is in operation, a separation distance of at least 20 cm (8 inches) must be
maintained between the radiating antenna inside the ERU and the bodies of all persons exposed to the
transmitter in order to meet the FCC RF exposure guidelines. Making changes to the antenna or the device is
not permitted. Doing so may result in the installed system exceeding RF exposure requirements. This device
must not be co-located or operated in conjunction with any other antenna or radio transmitter. Installers and
end users must follow the installation instructions provided in this guide.
FCC Part 68
This equipment complies with Part 68 of the FCC rules. On the bottom of this equipment is a label that
contains, among other information, the FCC equivalence number (REN) for this equipment. If requested, this
information must be provided to the telephone company.
The REN is used to determine the quantity of devices that may be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but
not all areas, the sum of the RENs should not exceed five. To be certain of the number of devices that may be
connected to the line, as determined by the total RENs, contact the telephone company to determine the
maximum REN for the calling area.
If the terminal equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. But if advance notice is not practical, the
telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that could
affect the operations of the equipment. If this happens, the telephone company will provide advance notice in
order for you to make the necessary modifications in order to maintain uninterrupted service.
If trouble is experienced with this equipment, please contact the store, reseller, or agent from whom the
product was purchased.
Repair of this equipment should be made only by the 2Wire Service Center or a 2Wire authorized agent.
2Wire
2Wire, Inc.
1704 Automation Parkway
San Jose, CA
12