DGT Bluetooth e-Board 설치 매뉴얼 - 페이지 4

{카테고리_이름} DGT Bluetooth e-Board에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DGT Bluetooth e-Board 15 페이지.
DGT Bluetooth e-Board에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지), 매뉴얼 (8 페이지)

페이지 인쇄

Metal surfaces under or frames very near your e-Board may reduce the sensitivity of the board. Please do not place

the e-Board on a metal table or a table with metal construction beneath or beside it.

Place the e-Board on a stable surface and connect the USB cable (included) between the e-Board and a free USB

port of your computer. Windows will automatically detect this new USB device and install the required windows driver

for the basic USB connection. The next step is to set-up the external Bluetooth dongle (if required) and the Bluetooth

connection.

Preparing the Bluetooth connection in Windows

If you have not yet installed a Bluetooth USB dongle (stick) or if you do not have built in Bluetooth hardware in your

computer or laptop, you need to insert a Bluetooth dongle (not included) in a free USB port of your computer.

Windows normally recognizes almost all of these dongles and will automatically install the driver included within the

Windows package, which is already on your computer.

If the installation does not start automatically, please install the drivers that came with your Bluetooth USB dongle.

When the Bluetooth device is ready for use, Windows will inform you as per following screen.

A Bluetooth plug icon (See: generic Bluetooth Radio) will appear in the system control panel as in following screen:

MA_ENG_Bluetooth Installation Manual_Rev 1508