Dell Latitude 3000 Series 서비스 매뉴얼 - 페이지 5

{카테고리_이름} Dell Latitude 3000 Series에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Latitude 3000 Series 43 페이지. 2-in-1
Dell Latitude 3000 Series에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지), 사용자 설명서 (9 페이지), 유틸리티 및 드라이버 설치 (4 페이지), 사양 (6 페이지), 기술 매뉴얼북 (45 페이지), 사양 (2 페이지), 시작하기 매뉴얼 (28 페이지), 설치 지침 (1 페이지), 빠른 시작 매뉴얼 (2 페이지), 설정 및 사양 (21 페이지), 매뉴얼 (25 페이지)

페이지 인쇄
Dell Latitude 3000 Series 서비스 매뉴얼
CMOS System
Options Not Set
CMOS Display
Type Mismatch
CMOS Memory Size
Mismatch
CMOS Time and
Date Not Set
Drive A or B is present but has
Diskette Boot
failed the BIOS POST.
Failure
Error in the DMA controller on
DMA Error
the system board.
DMA 1 Error
DMA 2 Error
The BIOS cannot communicate
FDD Controller
with the floppy drive or hard
Failure
drive controller.
HDD Controller
Failure
An interrupt channel on the
INTR1 Error
system board failed to POST.
INTR2 Error
The operating system cannot
Invalid Boot
be located on drive A or drive
Diskette
C.
The BIOS has detected a stuck
Keyboard Error
key.
An error occurred with the
KB/Interface
keyboard connector.
Error
The operating system cannot
No ROM Basic
be located on drive A or drive
C.
Back to Contents Page
 
Ensure that the drive is installed
correctly in the computer and defined
correctly in the
system setup
program.
Check the interface cable at both ends.
The keyboard or
system board
may
need to be replaced.
Ensure that the drive is installed
correctly in the computer and defined
correctly in the
system setup
program.
Check the interface cable at both ends.
The keyboard or
system board
may
need to be replaced.
Enter the system setup program
and
confirm that drive A or drive C is
properly identified.
Ensure that nothing is resting on the
keyboard; if a key appears to be stuck,
carefully pry it up. If the problem
persists, you may need to replace the
keyboard.
Ensure that nothing is resting on the
keyboard; if a key appears to be stuck,
carefully pry it up. If the problem
persists, you may need to replace the
keyboard.
Enter the system setup program
and
confirm that drive A or drive C is
properly identified.