CR-Tec ER PREMIER ER100 설치 및 운영 매뉴얼 - 페이지 3
{카테고리_이름} CR-Tec ER PREMIER ER100에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CR-Tec ER PREMIER ER100 11 페이지.
CR-Tec ER PREMIER ER100에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (17 페이지)
페이지 인쇄DESCRIPTION
These electric actuators have been designed to perform the control of a valve with 90° rotation. Please consult us for any different appli-
cation. We cannot be held responsible if the mentioned actuators are used in contradiction to this advice..
TRANSPORT AND STORAGE
The forwarding agents being held as responsible for damages and delays of the delivered goods, the consignees are obliged to ex-
press if applicable their reserves, prior to accept the goods. The goods delivered directly ex works are subject to the same conditions.
The transport to the place of destination is carried out by using rigid packing material.
The products must be stored in clean, dry, and ventilated places preferably on appropriate palettes or shelves.
MAINTENANCE
Maintenance is ensured by our factory. If the supplied unit does not work, please check the wiring according to the electric diagram as
well as the power supply of the concerned electric actuator.
For any question, please contact our after-sales service.
To clean the outside of the actuator, use a lint and soapy water. DO NOT USE CLEANING PRODUCT WITH SOLVENT OR ALCOHOL
SAFETY INSTRUCTIONS
The electric power supply must be switched-off before any intervention on the electric actuator (i.e. prior demounting its cover or ma-
nipulating the manual override knob).
Any intervention must only be carried out by a qualified electrician or other person instructed in accordance with the regulations of
electric engineering, safety, and all other applicable directives.
Strictly observe the wiring and set-up instructions as described in the manual: otherwise, the proper working of the actuator can not be
guaranteed anymore. Verify that the indications given on the identification label of the actuator fully correspond to the characteristics of
the electric supply.
Do not mount the actuator « upside down ». Risks:
Declutching mechanism failure
Possible flow of the grease on the electronic board
Do not mount the actuator less than 30 cm of a electromagnetic disturbances source.
Do not position the equipment so that it is difficult to operate the disconnecting device.
CR-TEC
To be read prior to the installation of the product
Engineering Inc.
• [email protected] • www.crtec.com • 203-318-9500
2