Avtech RMA-FS2-SEN 매뉴얼 - 페이지 2

{카테고리_이름} Avtech RMA-FS2-SEN에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtech RMA-FS2-SEN 4 페이지. Flood sensor - spot

Flood Sensor - Spot (RMA-FS2-SEN)

Step 2: Connect the battery.

Your Flood Sensor - Spot comes with a 9V alkaline

battery inserted into the retainer clip under the

housing.

Push the snap connector completely on to

the battery contacts. The snap connector

arrives partially off to prevent the battery from

discharging while it's stored and shipped.

Use only alkaline batteries in your sensor, and

replace the battery at least once a year. If your

Flood Sensor - Spot gets activated often, you may

need to replace it sooner.

Step 3: Mount your Flood Sensor - Spot.

1. Place your Flood Sensor - Spot on a flat surface in the area most prone to collect water.

2. You may simply rest the unit on its feet or remove the backing on the pads to stick it

to the surface. In either case, keep the feet on the unit: they create a gap necessary to

allow water to get to the contacts. If you remove them, the housing and surface may

form a seal, and water won't reach the contacts until it's risen up the sides or over the

top.

Step 4: Connect your Flood Sensor - Spot to Room Alert.

Do not connect the switch sensor inputs (dry contacts) on AVTECH products to any live

circuit.

Use only low-voltage 2-wire cable to connect switch sensor inputs.

Your sensor comes with one end of a 25' low-voltage 2-wire cable

already attached. The leads are non-polarized. Follow these steps

to attach the other end to a switch port on your Room Alert:

1. Separate and strip the leads on the free end of the speaker

cable, exposing about ¼" of wire.

2. Run the speaker cable back to your Room Alert. Try to avoid running it near large

electromagnetic devices or fluorescent lights, which produce EMI and can interfere with

sensor readings.

3. Connect the free ends (the 1/4" leads) of the speaker cable to an

open switch port on your Room Alert. Be sure the bare wire, not the

insulation, connects to the port. Again, the leads are non-polarized,

so you may connect either lead to either side of the open port.

Retainer

Clip

Page 2

Snap

Connector

Contacts

Feet