Avtech RMA-SS1-SEN 설치 참고 사항 - 페이지 2

{카테고리_이름} Avtech RMA-SS1-SEN에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtech RMA-SS1-SEN 3 페이지. Smoke sensor w/escape light
Avtech RMA-SS1-SEN에 대해서도 마찬가지입니다: 설치 참고 사항 (7 페이지)

페이지 인쇄

Smoke Sensor w/Escape Light (RMA-SS1-SEN)

Do not connect the dry contacts on AVTECH products or other electrical appliances

to live circuits.

Use only low-voltage 2-wire cable to connect dry contacts.

Configure Your Smoke Sensor w/Escape Light

With Room Alert's Built-In Web Interface

Settings Alarm Options

Navigate to

see below will vary depending on the model.

1. Scroll down to "Switch Sensor Settings."

2. Find the switch sensor label that matches the port you connected your sensor to. For

example, if you used the first switch sensor port on your Room Alert, look for "Sensor 1

Label"; if you used the second, look for "Sensor 2 Label," and so on.

3. In "Sensor X Label," you may leave the default name or enter something more

descriptive, such as "Server 8 Smoke" or "Smoke Rm 2."

4. In "Alarm On," choose "Closed," which means the smoke alarm has been triggered. The

default state is "Open," which means the smoke alarm has NOT been triggered.

5. For models with the "Use Alarm Profile" feature: if you have configured Alarm Profiles

in the Alarm Options screen, you may choose a profile from the drop-down menu.

Otherwise, you may leave the default, "No Alarm."

6. Click

Accept Changes

You may now navigate to another screen; however, if you close the web interface before

the next step, you will lose your changes.

7. Click

Save Settings

AVTECH Software, Inc.

in your Room Alert web interface. The options you

at the bottom of your screen to temporarily save your settings.

in the navigation bar to the left of your screen. Your Room Alert

Page 2 of 3

AVTECH.com