Avtech RMA-WTL2-SEN 설치 참고 사항 - 페이지 5

{카테고리_이름} Avtech RMA-WTL2-SEN에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtech RMA-WTL2-SEN 5 페이지. Tank level sensors

Configure Your Switch Sensor

Use Room Alert's Built-In Web Interface

Settings

Navigate to

below will vary depending on your Room Alert model.

1. Scroll down to Switch Sensor Settings.

2. Find the switch sensor label that matches the port you connected your switch sensor

to. For example, if you used the first switch sensor port on your Room Alert, look for

Sensor 1 Label; if you used the second, look for Sensor 2 Label, and so on.

3. In Sensor X Label, you may leave the default, "Switch Sen X," or enter something more

descriptive of up to 15 characters. You may use the following characters in sensor

labels: letters, numbers, spaces, hyphens (-), underscores (_) and periods (.).

4. In Alarm On, select the alarm state (

may find the alarm state of your switch sensor under the Features & Specifications

section of this Installation Note.

5. In Alarm Profile, which controls light towers and relays on your Room Alert, you may

leave the default,

Save Settings

6. Select

automatically reboot and commit your changes.

Sensors

in your Room Alert web interface. The options you see



Open

Profile 1

, or choose another profile from the drop-down menu.

at the top or bottom of the page. Your Room Alert will

Closed

) for your switch sensor. You

Page 5

AVT-171211-1.1.0