Dell PowerApp2 series 설치 매뉴얼 - 페이지 19
{카테고리_이름} Dell PowerApp2 series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerApp2 series 26 페이지. Dell poweredge 2650: installation guide
페이지 인쇄support.dell.com
Installing the Systems in the Rack
The subsections that follow include instructions for installing the systems in the rack.
CAUTION: If you are installing more than one system, install the first sys-
tem in the lowest available position in the rack. Never pull more than one
component out of the rack at a time.
1.
Pull the two interior slide assemblies out of the rack until they lock in the
extended position.
CAUTION: Because of the size and weight of the system, never attempt to
install the system in the slide assemblies by yourself.
NOTE: Skip to step 3 if your system does not have the optional bezel installed.
2.
Remove the optional bezel from the system front panel (see Figure 1-9):
a.
Unlock and open the system doors.
b.
Pivot the two locking levers toward the back of the chassis (see Figure 1-9).
c.
Press the tab on each end of the bezel and remove the bezel from the
chassis.
d.
Close the system doors.
Figure 1-9. Removing the System Bezel
3.
Lift the system into position.
Place one hand on the front-bottom of the system and the other hand on the
back-bottom of the system.
4.
Tilt the system while aligning the back shoulder nuts on the sides of the system
with the back slots on the slide assemblies (see Figure 1-10).
tabs (2)
Rack Installation Guide
locking levers (2)
1-11