Dell PowerEdge 2550 랙 설치 지침 - 페이지 11

{카테고리_이름} Dell PowerEdge 2550에 대한 랙 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2550 40 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2550에 대해서도 마찬가지입니다: 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (32 페이지), 구성 매뉴얼 (10 페이지), 활성화 매뉴얼 (32 페이지), 설치 매뉴얼 (32 페이지), 매뉴얼 (28 페이지), 매뉴얼 (15 페이지)

페이지 인쇄

F i g u r e 1 - 3 . Tw o - P o s t , O p e n - F r a m e R e l a y R a c k W i t h W i d e - H o l e S p a c i n g

3.5 inch (2 U)

CAUTION: The 2-U support tray is designed to support a single system in a

2 -post open frame relay rack. Do not attempt to install any other system in this

support tray. Damage to the system and personal injury to you and others may

result.

Flush-Mount Installation

This procedure uses the same support tray kit, but it does not use the center-mount

brackets.

Place the support tray into the rack with the bottom of the tray at the marks you made

in step 4 (for a universal-hole spacing rack) or in step 5 (for a wide-hole spacing rack)

in the section, "Marking the Rack." The center-mount brackets, the 10-32 x

0.375-inch truss-head screws, and the #10 internal-star washers are not used when

mounting the support tray's front mounting bracket flush against the 2-post rack.

If you are installing the support tray in a rack with universal-hole spacing, install four

12-24 x 0.5-inch pan-head Phillips screws to secure the support tray using the upper

and lower holes that you marked on the rack's front surface (see Figure 1-4).

An internally threaded stud projecting from the front of the tray flanges accepts the

captive fasteners on the front panel of the system.

1.75 inch (1

0.5 inch

1.25 inch

Ra c k In s ta l lati on Gui de

1-5