Dell PowerEdge 2550 랙 설치 지침 - 페이지 22
{카테고리_이름} Dell PowerEdge 2550에 대한 랙 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2550 40 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2550에 대해서도 마찬가지입니다: 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (32 페이지), 구성 매뉴얼 (10 페이지), 활성화 매뉴얼 (32 페이지), 설치 매뉴얼 (32 페이지), 매뉴얼 (28 페이지), 매뉴얼 (15 페이지)
페이지 인쇄
Place the bracket from the right slide assembly on the threaded studs on the left slide
3
assembly, with the bracket turned 180 degrees so that the mounting flange faces
forward (see Figure 1-12).
Secure each center mount bracket (by its locking nuts and shoulder washer) finger
4
tight on their opposite slide assemblies using the two shoulder washers and two
locking nuts you removed in step 2 (see Figure 1-12).
F i g u r e 1 - 1 2 . P o s i t i o n i n g B r a c k e t s f o r F l u s h - M o u n t I n s t a l l a t i o n
Holding the left slide assembly into position in the two-post rack at the location
5
you marked, adjust the front and rear brackets tightly against the vertical two-post
rack and secure the front and rear center mounting brackets to the rack with
two 12-24 x 0.5-inch pan-head Phillips screws on each back mounting flange.
Perform steps 3 through 6 to install the right slide assembly in the rack.
6
The guide pin on the mounting flange should enter a mounting hole in the rack
7
(see Figure 1-13).
Use a 3/8-inch nut driver to fully tighten the locking nuts on the mounting brackets
8
that were finger tight.
1-16
Rac k I n st allat io n G uide
alignment
holes