Avtech CSD-714 Selcal 설치 매뉴얼 - 페이지 12

{카테고리_이름} Avtech CSD-714 Selcal에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtech CSD-714 Selcal 20 페이지.

CSD-714 Installation and Operation Manual

There is no charge for a code assignment at this time. This code is assigned to the USER and does

NOT transfer with the aircraft when it is sold.

INSTALLATION TESTING

The following tests should be performed to verify the installation in the airplane is operating

properly:

Apply power to the unit and press the SELF-TEST button to initiate a SELF-TEST. Within

approximately four seconds an indication of a SELCAL decode should be received on all

annunciators simultaneously.

Using a ground test set such as the Avtech CTS-700 SELCAL/ATSCALL Ramp Test Set,

select the frequency for test on one of the communication transceivers to which the CSD-714

is connected. On the test frequency generate a SELCAL encoded signal of the code sequence

programmed into the CSD-714. Confirm that the appropriate annunciator lamp illuminates

and the chime is heard, if installed. Take the appropriate action to reset the unit. Do this test

for all SELCAL channels and for all radios connected to the CDS-714.

If possible, contact the agency which will be furnishing SELCAL service to the aircraft and

request a test call.

Avtech

Part Number

1200008-000

1200008-001

1200008-002

1200008-003

1200009-000

2000008-003

1200011-000

1000005-001

Seattle, WA USA

Description

CSD-714 SELCAL (5 channel, standard self-test)

CSD-714 SELCAL (2 channel, standard self-test)

CSD-714 SELCAL (5 channel, auto-reset self-test)

CSD-714 SELCAL (2 channel, auto-reset self-test)

Attenuator,Audio,20 dB

Connector, Rack Mounted W/Pins

Rack, Mounting, 1 MCU

Test Set, CTS-700 SELCAL/ATSCALL Ramp Test System

23-21-01

Rev 1

June 1995

Page 6