Dell PowerEdge 2850 보충 설명서 - 페이지 6
{카테고리_이름} Dell PowerEdge 2850에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2850 20 페이지. Dell server quick reference
Dell PowerEdge 2850에 대해서도 마찬가지입니다: 설치 매뉴얼 (32 페이지), 지원 매트릭스 (21 페이지), 정보 업데이트 (24 페이지), 매뉴얼 (44 페이지), 빠른 참조 (2 페이지), 사용자 설명서 (30 페이지)
페이지 인쇄
5
Replace the processor(s).
6
If applicable, replace the RAC card.
7
If applicable, replace the RAID key.
8
Replace the power supply(s).
9
Install the new riser board provided in your upgrade kit.
Raise the riser board cam lever to a vertical position. See Figure 1-1.
a
Lower the riser board into position
b
•
•
When you are certain the riser board is correctly aligned with the system board, carefully
c
close the cam lever to lock the riser board into place.
If you disconnected the SCSI data cable while removing the riser board, reconnect the
d
cable to the riser board.
10
Place the plastic riser board insulator over the riser board and press down on the two plastic
rivets to secure the insulator.
11
Reconnect the fan power cables.
12
Replace the SCSI backplane board and reinstall the SCSI hard drives. See "SCSI Backplane
Board" in the Service-Only Parts Replacement Procedures guide on support.dell.com.
13
Reinstall the cover.
14
If applicable, reattach the bezel.
6
Upgrading Your System Board and Riser Board
The cam lever fits through the opening near the outer edge of the riser board.
Align the connector on the underside of the riser board with the corresponding
connector on the system board.