Dell PowerEdge 860 설치 매뉴얼 - 페이지 2
{카테고리_이름} Dell PowerEdge 860에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 860 28 페이지. Sas/raid controller installation
Dell PowerEdge 860에 대해서도 마찬가지입니다: 정보 업데이트 (14 페이지), 설치 지침 매뉴얼 (7 페이지), 서비스 매뉴얼 (37 페이지)
페이지 인쇄
Insert the card-edge connector firmly into the system-board card connector until the card
b
is fully seated.
NOTE:
Some systems use a plastic bar to secure the expansion-card bracket to the back panel
instead of a screw.
Install the screw that secures the expansion-card bracket to the back panel.
c
6
Close the system. See "Closing the System" in the Installation and Troubleshooting Guide for
instructions.
Figure 1. Installing the DRAC 4/P Card
DRAC 4/P card
card-interface
connector
interface cable
RAC connector
7
Connect the monitor cable to the card video connector on the DRAC 4/P card. See Figure 2.
The monitor cable must be connected to the card video connector on the DRAC 4/P card—
not to the system's integrated video connector.
8
Connect the network to the card NIC connector on the DRAC 4/P card. See Figure 2.
The network cable must be connected to the card NIC connector on the DRAC 4/P card—
not to the system's integrated NIC connector.
9
Reattach the system to its AC power source and turn on the system.
expansion-card bracket
The connectors on your system board and the actual
expansion slot that you use may vary on your system board.
screw
card-edge
connector
system-
board card
connector
expansion
slot