Dell Precision M20 서비스 매뉴얼 - 페이지 16

{카테고리_이름} Dell Precision M20에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Precision M20 48 페이지. Dell precision m20 service manual

M2 x 3-mm screws (4)

8. Remove the display panel from the top cover.

9. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.

1 top flex-cable connector

2 top display-cable connector

3 pull-tab on bottom flex-cable

connector

10. Press in both sides of the top display cable connector, and pull the display cable connector away from the top flex-cable connector.

1. Connect the top display cable connector to the top flex-cable connector.

2. Connect the bottom flex-cable connector to the inverter connector.

3. Replace the display panel inside the top cover.

4. Tighten the four M2 x 3-mm screws (two on each side) around the display panel.

5. Replace the

display bezel.

Display Latch

NOTICE:

Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

1. Follow the instructions in "Preparing to Work Inside the Computer."

2. Remove the

center control

cover.

3. Remove the keyboard.

4. Remove the

display

assembly.

5. Remove the

display

bezel.

6. Remove the M2.5 x 5-mm screw that secures the display latch to the top cover.

6M871 (flex cable, top flex-cable

connector, and pull-tab)