Craden DP8 보충 설명서 - 페이지 5

{카테고리_이름} Craden DP8에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Craden DP8 18 페이지. Transaction printers
Craden DP8에 대해서도 마찬가지입니다: 기술 매뉴얼 (8 페이지), 설치 매뉴얼 (2 페이지), 지원 데스크 매뉴얼 (19 페이지)

페이지 인쇄

5.4.1.1 Ribbon Shield Removal / Replacement

The ribbon shield prevents ribbon fabric from rubbing on and smearing printed media. It is a

consumable. Replace the shield every four to five ribbon replacements or when it is damaged.

Open the cabinet, center the carriage and pull the

lifter ring out and down to raise the carriage. Remove

the ribbon cartridge.

Tabs

Pull the ribbon guide plate tabs toward

you. Insert the new shield tips into the gap

between the ribbon guide plate and the

carriage

Push the shield up until it stops.

Install the ribbon cartridge and

lower the carriage.

Lifter

Ring

Carriage

Ribbon

Guide Plate

Shield

Tips

Carriage

Shaft

Lift the carriage shaft with one hand and

pull the shield down and out to the right

with the other.

Rotate the shield until it is centered on

the carriage. Do not let the shield tips

slip behind the carriage.

Move the carriage lifter ring up and in to lower

the carriage. Close the cabinet turn the printer

on and do a test print or transaction.