Craden DP8 지원 데스크 매뉴얼 - 페이지 19

{카테고리_이름} Craden DP8에 대한 지원 데스크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Craden DP8 19 페이지. Transaction printers
Craden DP8에 대해서도 마찬가지입니다: 기술 매뉴얼 (8 페이지), 설치 매뉴얼 (2 페이지), 보충 설명서 (18 페이지)

페이지 인쇄

Is the display on the printer blank?

Do the keys on the keypad work?

See page 13 for functions and

exercise keys

Yes

Will the printer take a document

when it is placed into the machine?

Yes

Does the carriage move when printer

should be printing? Open cabinet

and override cover open sensor

using 99 FUNCT (pg. 4)

Yes

Does the printer print? Insert paper

and press 900 FUNCT on the

keypad (pg. 15)

Yes

Is the printed output smearing?

Is the printed output too light?

Do the rollers run continuously, even

when paper is not in the printer?

Is the printed output spaced

correctly?

Yes

Does the printer communicate with

the system when you send a

transaction?

End

DIAGNOSTIC FLOWCHART

Use this flow chart to assist in troubleshooting.

 Power switch is ON

 Power cord plugged in both ends

 Contrast knob adjusted (pg. 14)

Yes

 Power outlet is live

 Is the keypad locked? (pg. 14)

 Press EJECT & CLEAR and try again

 Insert paper, press A key (see printer parameter,

 Check sensors (pg. 12)

 Carriage Fault on display? Foam packing removed?

 Insert paper, press A key (see printer parameter, BEGIN

 Ribbon correctly installed? (pg. 5)

 Ribbon shield installed correctly? (pg. 6)

 Remove ribbon, check for jammed cartridge

 Check that ribbon knob turns as carriage moves

 Ribbon correctly installed? Ribbon worn out? (pg. 5)

 Ribbon shield installed correctly? (pg. 6)

Yes

 Document too thick?

 Printing in non-printable area of a document or passbook?

 Ribbon correctly installed? Ribbon worn out? (pg. 5)

 Remove ribbon, check for jammed cartridge

Yes

 Ribbon shield installed correctly? (pg. 6)

 Quiet mode set to Y? Darkness set too low? (pg. 4)

 Does the ribbon knob turn as carriage moves?

 Ribbon guide plate pushed up completely? (pg. 6)

Yes

 Paper dust or debris inside printer. (pg. 13)

 Blow out debris with compressed air.

 Multisensor cable seated correctly? (pg. 13)

 Characters per inch setting OK? (see printer parameter,

 Check all service parameters. (pg. 4)

 Check interface cable mounting (pg. 3)

 Communication parameters match host system? (pg. 3)

DOCUMENT INSERT, pg. 4)

PRINTING, pg. 4)

LINES/INCH, pg. 4)