Dell Studio 1569 서비스 매뉴얼 - 페이지 12
{카테고리_이름} Dell Studio 1569에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Studio 1569 48 페이지.
페이지 인쇄Back to Contents Page
Processor Module
Dell™ Studio™ 1569 Service Manual
Removing the Processor Module
Replacing the Processor Module
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press
to apply slight pressure to the center of the processor while turning the cam screw.
CAUTION:
To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Processor Module
1. Follow the procedures in
Before You
2. Remove the battery (see
Removing the
3. Follow the instructions from
4. Remove the processor heat sink (see
5. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
1
ZIF socket
3
ZIF-socket cam screw
CAUTION:
To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The
oils in your skin can reduce the heat transfer capability of the thermal pads.
CAUTION:
When removing the processor module, pull the module straight up. Be careful not to bend the pins on the processor module.
6. Lift the processor module from the ZIF socket.
Begin.
Battery).
step 3
to
step 17
in
Removing the System
Removing the Processor Heat
2
Pin-1 corner
Removing the
Board.
Sink).
Battery) before working inside the