Dell Studio XPS 1340 서비스 매뉴얼 - 페이지 16

{카테고리_이름} Dell Studio XPS 1340에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Studio XPS 1340 40 페이지.

8. Disconnect the display cable, power light cable, and camera cable from their system board connectors and dislodge the cables from their routing guides.

9. Remove the four screws (two on either side) that secure the display assembly to the computer base.

10. Lift the display assembly off the computer.

NOTICE:

To avoid damage to the display, you must not disassemble your Edge-to- Edge display assembly.

screws (total 4; 2 on each side)

power light cable connector

display cable grounding screw

Replacing the Display Assembly

NOTICE:

To avoid damage to the display, you must not disassemble your Edge-to- Edge display assembly.

1. Place the display assembly in position and replace the four screws (two on either side) that secure the display assembly.

2. Replace the display cable grounding screw that secures the display ground cable to the system board.

3. Carefully slide the Mini-Card antenna cables through the system board and into their routing guides.

4. Reconnect the Mini-Card cables to the Mini-Card, if applicable (see

5. Route the power light cable and camera cable through the routing guides and connect the cables to the respective system board connectors.

6. Replace the optical drive (see

7. Replace the palm rest (see

NOTICE:

Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may

result in damage to the computer.

Back to Contents Page

display cable pull-tab

camera cable connector

Replacing the Optical

Drive).

Replacing the Palm

Rest).

Replacing the

Mini-Card).