Dell Studio XPS 1340 서비스 매뉴얼 - 페이지 21
{카테고리_이름} Dell Studio XPS 1340에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Studio XPS 1340 40 페이지.
페이지 인쇄Back to Contents Page
Rear Caps
Dell™ Studio XPS™ 1340 Service Manual
Removing the Rear Caps
Replacing the Rear Caps
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Before performing this procedures, turn off the computer, disconnect the AC adapter from the electrical outlet and the computer,
disconnect the modem from the wall connector and the computer, and remove any other external cables from the computer.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
NOTICE:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is
not covered by your warranty.
NOTICE:
To help prevent damage to the system board, remove the main battery (see "Before Working Inside Your Computer" on page 10)
before working inside the computer.
Removing the Rear Caps
1. Follow the instructions in
Before You
2. Remove the base cover (see
3. Remove the three screws that secure the left and right rear caps to the computer base.
4. Lift the rear caps off the computer base.
1
rear caps
Replacing the Rear Caps
1. Replace the rear caps.
2. Replace the three screws that secure the left and right rear caps to the computer base.
3. Replace the base cover (see
4. Slide the battery into the battery bay until it clicks into place.
Back to Contents Page
Begin.
Removing the Base
Cover).
2
screws (3)
Replacing the Base
Cover).