Dell Studio XPS 1340 서비스 매뉴얼 - 페이지 29

{카테고리_이름} Dell Studio XPS 1340에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Studio XPS 1340 40 페이지.

4. Remove the screw that secures the Mini-Card to the system board.

5. Lift the Mini-Card out of the system board connector.

NOTICE:

When the Mini-Card is not in the computer, store it in protective antistatic packaging. For more information, see "Protecting Against

Electrostatic Discharge" in the safety information that shipped with your computer.

Replacing the Mini-Card

1. Remove the new Mini-Card from its packaging.

NOTICE:

Use firm and even pressure to slide the card into place. If you use excessive force, you may damage the connector.

2. Insert the Mini-Card connector at a 45-degree angle into the appropriate system board connector. For example, the WLAN card connector is labeled

WLAN and so on.

3. Press the other end of the Mini-Card down into the slot on the system board.

4. Replace the securing screw.

5. Connect the appropriate antenna cables to the Mini-Card you are installing. The following table provides the antenna cable color scheme for the Mini-

Card supported by your computer.

Connectors on the Mini-Card

WWAN (2 antenna cables)

Main WWAN (white triangle)

Auxiliary WWAN (black triangle)

WLAN (2 antenna cables)

Main WLAN (white triangle)

Auxiliary WLAN (black triangle)

WPAN (one antenna cable)

WPAN

6. Secure the unused antenna cables in the protective mylar sleeve.

7. Replace the base cover (see

8. Slide the battery into the battery bay until it clicks into place.

9. Install the drivers and utilities for your computer, as required. For more information, see the Dell Technology Guide.

NOTE:

If you are installing a communication card from a source other than Dell, you must install the appropriate drivers and utilities. For more generic

driver information, see the Dell Technology Guide.

Antenna Cable Color Scheme

white with gray stripe

black with gray stripe

white

black

blue

Replacing the Base

Cover).