Dell Vostro 1200 서비스 매뉴얼 - 페이지 8

{카테고리_이름} Dell Vostro 1200에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Vostro 1200 42 페이지. Dell vostro setting up
Dell Vostro 1200에 대해서도 마찬가지입니다: 빠른 설정 (2 페이지)

Dell Vostro 1200 서비스 매뉴얼
Back to Contents Page
  Processor Module
Dell™ Vostro™ 1200 Service Manual 
  Removing the Processor Module
  Replacing the Processor Module
 Removing the Processor Module
 
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
Do not touch the processor die. Press and hold the processor down on the substrate on which the die is mounted while turning the cam screw
to prevent intermittent contact between the cam screw and processor.
NOTICE:
To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
 
1. Follow the instructions in
Before You
 
2. Remove the battery (see
Removing the
NOTICE:
To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The oils in
your skin reduce the heat transfer capability of the thermal pads.
 
3. Remove the processor thermal-cooling assembly (see
The processor is located under the processor thermal-cooling assembly.
NOTICE:
When removing the processor module, pull the module straight up. Be careful not to bend the pins on the processor module.
 
4. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
1 processor module
2 pin-1 corner of microprocessor
3 ZIF-socket cam screw  
 
NOTE:
The ZIF-socket cam screw secures the processor to the system board. Take note of the arrow on the ZIF-socket cam screw, which indicates the
direction to turn the cam screw.
 
5. Lift the processor module from the ZIF socket.
 Replacing the Processor Module
Begin.
Battery).
Removing the Processor Thermal-Cooling
Assembly).