DH Gibralter GE-MINI 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} DH Gibralter GE-MINI에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DH Gibralter GE-MINI 10 페이지.

Assembling the Antenna to the Ring

The mount should be assembled at this point. Now it is time to install the antenna.

Locate the 1/8" pilot hole; one is located next to one of the six, 5/ 8" holes in the 2.4M/

2.7M dish and the other is found on one of the 6 tabs on the mount next to the 5/ 8"

holes. (NOTE: These holes do not line up with one another, they are only to identify the

alignment of the dish to the mount.) Place the ring in a vertical position. (see fig. #1)

Bring the dish vertically to the ring. Align the pilot holes. Insert a ½" bolt, metal washer,

rubber washer into the ½" holes in from the front of the dish. You will use every other

hole at this point, which will be 3 holes.

between the dish and the ring tab.

nut (loosely tighten). Next install the feed struts. The feed struts will be installed in the

remaining 3 holes. Use this sequence: bolt, metal washer, feed strut, rubber washer. On

the backside of the dish, insert a rubber washer between the dish and the ring tab,

followed by a lock washer and a nut. Please do not tighten nuts at this point. Next

install the feed collar (C 13F collar) unto the feed struts. Secure with 6- ¼"x 1 ½" bolts

and ¼" locknuts. See photo group #1. Your next step is to tighten the six bolts that

secure the dish to the ring.

addressed in Preparing the Feed Assembly.

Fig. #1

Behind the dish you must insert a rubber washer

Secure the bolt with a lock washer followed with a ½"

DO NOT OVER TIGHTEN.

This photo is simply showing the mount in vertical

position after we have accepted the antenna to the

mounting ring. Feed struts are installed after the

antenna has been bolted to the ring. Please note

that the 2.4m & 2.7m only have 3 struts while the

3.0m will be using 4 struts with the 48" ring as

shown.

(2.4m &2.7m)

This is also

1/4" Lock Washers & Nuts

Photo Group #1

PAGE 7