Dell Vostro A100 서비스 매뉴얼 - 페이지 10
{카테고리_이름} Dell Vostro A100에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Vostro A100 31 페이지.
페이지 인쇄11. Ensure that all the cables are properly connected and firmly seated.
12. Replace the computer cover on both the sides (see
13. Connect your computer and devices to electrical outlets, and then turn them on.
Replacing an Optical Drive
1. Follow the procedures in
Before You
2. Remove the computer cover (see
3. Disconnect the power cable and the optical drive data cable from the drive.
NOTE:
If you are uninstalling the only optical drive in your computer and will not replace it at this time, disconnect the data cable from the system
board and set it aside.
4. Remove the four screws securing the optical drive to the chassis.
5. Push and slide the optical drive out through the front of the computer.
1
screws (4)
2
system board connector
4
data cable
5
optical drive
6. To replace the optical drive, gently slide the drive into place.
7. Align the screw holes in the optical drive with the screw holes in the optical drive bay.
8. Replace the four screws that secure the optical drive to the chassis.
9. Connect the power and data cables to the drive.
10. Replace the computer cover on both the sides (see
11. Connect your computer and devices to their electrical outlets and turn them on.
NOTE:
If you installed a new drive, see the documentation that came with the drive for instructions on installing any software required for drive
operation.
Back to Contents Page
Replacing the Computer
Begin.
Replacing the Computer
Cover).
3
power cable
Replacing the Computer
Cover).
Cover).