Avtek 1EVA11 빠른 매뉴얼 - 페이지 4

{카테고리_이름} Avtek 1EVA11에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtek 1EVA11 6 페이지.

페이지 인쇄

Avtek 1EVA11

Wireless projection screen trigger

1. Features

• Detects projector startup and sends signal to controller screen.

• Compatibile with all Avtek electric screens:

"Video/Cinema/ Business Electric" series and Wall Electric

equipped with the 1EVA06 controller.

• Integrated overvoltage protection sensor for better safety

• High resistance to interference

2. Specification

Model

Power

Supply

AC 230 V

50 Hz

512‑02

(optionally: AC

120 V 60 Hz)

3. Installation and setup

Important safety precautions

While installing the product, please make sure you follow all the applicable electrical standards and the following safety precautions:

• Before you start any (re)installation or maintenance work, always disconnect the product from the mains first.

• Use all appropriate electrical safety measures to protect electrical components of the product from damage by electrostatic discharge.

• Make sure that the electrical ground wire is correctly connected.

projector power cable

Temperature

Transmit

Power

‑20°C ~ +55°C

≤ 10 mW

CODE: that button is present on the receiver and on

LED indicator

the trigger unit. Use these buttons to pair the trigger

and the receiver.

SET: a button on the trigger unit. Use that button to set

Power input: AC 230 V 50 Hz

up the trigger to work with your projector.

(optionally: AC 120 V 60 Hz)

Maximum

Operating

load

frequency

≤ 1000 W

433.92 Hz

CODE button

wireless trigger

Power consumption

in stand-by mode

≤ 1 W

SET button

Receiver