Avtek AC 512-02 빠른 매뉴얼 - 페이지 5
{카테고리_이름} Avtek AC 512-02에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtek AC 512-02 6 페이지.
페이지 인쇄4. Operating instructions
Pairing the trigger with the receiver
Having connected the receiver to the mains, press the "CODE" button on the receiver and hold it pressed for 1 second. The
red LED indicator on the receiver will start blinking and it will keep blinking for 10 seconds. During that time press the "CODE"
button on the trigger unit. When the two devices are paired correctly, the blue LED indicator on the receiver will blink three
times quickly.
Power on
Press CODE on receiver
for 1 second
Setting up the trigger to work with the projector
Having connected the trigger to the mains, press the "SET" button and hold it pressed for 3 seconds. The LED indicator on the
trigger will start blinking. It will keep blinking for 10 seconds and will also sound a single short beep. Next, turn the projector on.
The trigger will remember the necessary settings automatically.
As soon as the trigger has been set up to work with the projector correctly, the LED indicator on the trigger will blink 3 times
and the trigger will sound 3 short beeps.
If there is only one beep and the LED indicator lights up only once, that will mean the setting has failed.
Press SET on receiver
Power on
for 3 sec.
If the devices have been set up correctly, they will interact with each other as follows:
As soon as the projector has been turned on, the projection screen will be lowered automatically.
As soon as the projector has been turned off, the projection screen will be rolled up automatically.
within 10 seconds
Red light on receiver
flashes slowly for 10 sec.
BEEP
within 10 seconds
Buzzer
Red light on receiver
buzz
flashes slowly for 10 sec.
5
Press CODE
Blue light on receiver
on the trigger
flashes quickly 3 times
Led on trigger flashes quickly 3 times
with buzzer 3 times beep
Turn on
the projector
Led on trigger flashes 1 time
with buzzer 1 time beep
Receiver paired
BEEP
3x
Setting
successfull
BEEP
1x
Setting
failed