Dell XPS 17 9700 연결 매뉴얼 - 페이지 5

{카테고리_이름} Dell XPS 17 9700에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell XPS 17 9700 13 페이지. External display connection
Dell XPS 17 9700에 대해서도 마찬가지입니다: 설정 및 사양 (23 페이지)

페이지 인쇄

Enable Direct Graphics Controller Direct Output mode

You can connect four external displays or two 8K displays on computers with the NVIDIA GeForce RTX 2060 discrete graphics

card installed, you must enable Direct Graphics Controller Direct Output Mode in the computer's BIOS.

NOTE:

When enabled, the graphics signals are sent to the external display using the discrete graphics card instead of

integrated graphics. By default, this mode is disabled in the computer's BIOS.

To change Direct Graphics Controller Direct Output Mode in the computer's BIOS:

1. Restart the system and immediately press <F2> to enter the BIOS.

2. On the BIOS screen, select Display.

3. Select Direct Graphics Controller Direct Output mode.

4. Select Enable.

5. Save changes and exit the computer's BIOS

For more information about accessing and configuring the BIOS, see the computer's Service Manual at www.dell.com/support.

Turn off the internal display

There may be instances where you may want to turn off the computer's internal display to connect more external displays.

You can turn off the LCD display of your computer by using the Intel HD Graphics Command Center.

To turn off the display:

1. In the Windows search bar, type Intel Graphics Command Center and press <Enter>.

2. Accept the Intel Graphics Command Center software licence agreement.

3. On the Intel Graphics Command Center window, click Display. The list of active displays is listed under the Connected

Displays section.

4. Click the ellipsis (...) in the top-right corner of your primary display, then click Extend > Display 2.

5. Click the ellipsis (...) in the top-right corner of display 2, then click Make Display Primary.

Before you begin