Dell 1537 - Studio Core 2 Duo T6400 2.0GHz 4GB 320GB 서비스 매뉴얼 - 페이지 32
{카테고리_이름} Dell 1537 - Studio Core 2 Duo T6400 2.0GHz 4GB 320GB에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell 1537 - Studio Core 2 Duo T6400 2.0GHz 4GB 320GB 42 페이지. Dell laptop setup instruction
Dell 1537 - Studio Core 2 Duo T6400 2.0GHz 4GB 320GB에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지), 컴퓨터 설정 (2 페이지)
페이지 인쇄
Back to Contents Page
Wireless Mini-Card
Dell™ Studio 1535/1536 Service Manual
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
Your computer supports three Mini-Card slots:
Two Full Mini-Card slots – for WWAN, WPAN, UWB, Bluetooth
l
One Half Mini-Card slot – for WLAN
l
NOTE:
Depending on the configuration of your system, one or more of the Mini-Cards might not be present.
The types of Mini-Cards supported are:
Wireless Local Area Network (WLAN) — Half Mini-Card
l
Ultra Wide Band (UWB) — Full Mini-Card
l
Mobile broadband or Wireless Wide Area Network (WWAN) — Full Mini-Card
l
Wireless Personal Area Network (WPAN) or Internal Card with Bluetooth
l
NOTE:
Your computer can only support two Full Mini-Cards and one Half Mini-Card at a time.
NOTE:
The WLAN slot supports a half Mini-Card.
Removing the Mini-Card
1. Follow the instructions in
Before You
2. Remove the base cover (see
NOTICE:
When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking tabs; if
you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep them evenly
aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.
3. Disconnect the antenna cables from the Mini-Card.
1 WWAN/WLAN Mini-Card
2 M2 x 3-mm securing screw
NOTE:
If you are removing a WPAN/UWB Mini-Card, disconnect the blue antenna cable from the Mini-Card.
4. Remove the securing screw that connects the Mini-Card to the system board.
5. Lift the Mini-Card out of the system board connector.
Begin.
Removing the Base
Cover).
3 antenna cable connectors (2)
®
Wireless Technology — Full Mini-Card