Dell 3008WFP - UltraSharp - 30" LCD Monitor 사용자 설명서 - 페이지 17
{카테고리_이름} Dell 3008WFP - UltraSharp - 30" LCD Monitor에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell 3008WFP - UltraSharp - 30" LCD Monitor 38 페이지. Flat panel monitor
Dell 3008WFP - UltraSharp - 30" LCD Monitor에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지), 사양 (2 페이지), 브로셔 (2 페이지)
페이지 인쇄
B
Use this button to activate Picture by Picture (PBP) mode adjustment.
Picture by Picture
(PBP) Select
C
Use the MENU button to launch the on-screen display (OSD) and select the OSD Menu. See
OSD Menu/Select
D
Use this button for direct access to the "Brightness" and "Contrast" control menu.
Brightness/Contrast
Hot Key
E
Use these buttons to navigate and adjust the slider-bar (decrease/increase ranges) controls in the OSD.
Down (-) and Up (+)
F
Use this button to activate automatic setup and adjust menu. The following dialog appears on a black screen as the monitor self-adjusts
to the current input:
Auto Adjust
Auto Adjustment allows the monitor to self-adjust to the incoming video signal. After using Auto Adjustment, you can further tune your
monitor by using the Pixel Clock (Coarse) and Phase (Fine) controls under DISPLAY SETTINGS.
NOTE:
Auto Adjust does not occur if you press the button while there are no active video input signals or attached cables.
G
Use the Power button to turn the monitor on and off.
The blue LED indicates the monitor is on and fully functional. An amber LED indicates DPMS power save mode.
Power button
(with power light
indicator)
Using the On-Screen Display (OSD) Menu
Accessing the Menu System
NOTE:
If you change the settings and then either proceed to another menu or exit the OSD menu, the monitor automatically saves those
changes. The changes are also saved if you change the settings and then wait for the OSD menu to disappear.
1.
Push the MENU button to launch the OSD menu and display the main menu.
Main Menu for Analog (VGA) Input
or
Main Menu for non Analog (non VGA) Input
or
or
Accessing the Menu
System.