Dell 3008WFP - UltraSharp - 30" LCD Monitor 사용자 설명서 - 페이지 22
{카테고리_이름} Dell 3008WFP - UltraSharp - 30" LCD Monitor에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell 3008WFP - UltraSharp - 30" LCD Monitor 38 페이지. Flat panel monitor
Dell 3008WFP - UltraSharp - 30" LCD Monitor에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지), 사양 (2 페이지), 브로셔 (2 페이지)
페이지 인쇄
Display Reset Reset the image to the original factory setting.
Exit Menu
Push
OTHER
SETTINGS
Back
Push
Language
Language option to set the OSD display to one of five languages (English, Espanol, Francais, Deutsch, or Japanese).
Menu
This function is used to adjust the OSD background from opaque to transparent.
Transparency
Menu Timer
OSD Hold Time: Sets the length of time the OSD will remain active after the last time you pressed a button.
Use the
Menu Lock
Controls user access to adjustments. When 'Lock'
button.
NOTE:
selected on entry. Press and hold
Audio
To turn on or off audio power during power save mode.
Options
Default is "Enable". Select Disable to disable this feature.
Yes — Turn off audio power during power save mode.
No — Turn on audio power during power save mode.
Audio
Audio offers two kind of configurations of audio channels. Use the
Configuration
and and select the desired option.
DDC/CI
DDC/CI (Display Data Channel/Command Interface) allows your monitor parameters (brightness, color balance etc) to be adjustable
via software on your PC. You can disable this feature by selecting "Disable".
Default is "Enable". Select Disable to disable this feature.
Enable this feature for best user experience and optimum performance of your monitor.
Below warning message appears when you select "Enable DDC/CI":
LCD
If an image appears to be stuck on the monitor, select LCD Conditioning to help eliminate any image retention. Using the LCD
Conditioning
Conditioning feature may take several hours. Severe cases of image retention are known as burn-in, the LCD Conditioning feature
does not remove burn-in.
Below warning message appears when you select "Enable LCD Conditioning":
NOTE:
Factory
Reset all OSD settings to the factory preset values.
to exit the OSD main menu.
to go back to the main menu.
and
buttons to adjust the slider in 1 second increments, from 5 to 60 seconds.
When the OSD is locked, pressing the menu button will take the user directly to the OSD settings menu, with 'OSD Lock' pre-
button for 15 seconds to unlock and allow user access to all applicable settings.
Use LCD Conditioning only when you experience a problem with image retention.
is selected, no user adjustments are allowed. All buttons are locked except
or
button to move between 2 channels and 5.1 channels