Dell D28M 설정 및 사양 매뉴얼 - 페이지 28
{카테고리_이름} Dell D28M에 대한 설정 및 사양 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell D28M 38 페이지.
Dell D28M에 대해서도 마찬가지입니다: 설정 및 사양 (20 페이지), 설정 및 사양 (20 페이지), 설정 및 사양 (19 페이지), 설정 및 사양 (20 페이지)
페이지 인쇄
Table 24. Video
Option
Security
Table 25. Security
Option
Admin Password
System Password
Internal HDD-0 Password
Password Configuration
Password Bypass
Password Change
UEFI Capsule Firmware
Updates
TPM 2.0 Security
Absolute
28
System setup
Description
● Auto (default)
● Intel HD Graphics
NOTE:
If you do not select Auto, the on-board graphics device will be present and
enabled.
Description
Allows you to set, change, and delete the admin password.
Allows you to set, change, and delete the system password.
Allows you to set, change, and delete the computer's internal hard drive password.
Allows you to control the minimum and maximum number of characters that are allowed for
an administrative password and the system password. The range of characters is between 4
and 32.
This option lets you bypass the System (Boot) Password and the internal hard drive
password prompts during a system restart.
● Disabled — Always prompt for the system and internal HDD password when they are set.
This option is disabled by default.
● Reboot Bypass — Bypass the password prompts on Restarts (warm boots).
NOTE:
The system will always prompt for the system and internal HDD passwords when
powered on from the off state (a cold boot). Also, the system will always prompt for
passwords on any module bay HDDs that may be present.
This option lets you determine whether changes to the System and Hard Disk passwords are
permitted when an administrator password is set.
Allow Non-Admin Password Changes - This option is enabled by default.
This option controls whether this system allows BIOS updates via UEFI capsule update
packages. This option is selected by default. Disabling this option will block BIOS updates
from services such as Microsoft Windows Update and Linux Vendor Firmware Service
(LVFS).
Allows you to control whether the Trusted Platform Module (TPM) is visible to the operating
system.
● TPM On (default)
● Clear
● PPI Bypass for Enable Commands
● PPI Bypass for Disable Commands
● PPI Bypass for Clear Commands
● Attestation Enable (default)
● Key Storage Enable (default)
● SHA-256 (default)
Choose any one option:
● Disabled
● Enabled (default)
This field lets you Enable, Disable or permanently Disable the BIOS module interface of the
optional Absolute Persistence Module service from Absolute Software.
● Enabled - This option is selected by default.
● Disable