ABB 6310408P 제품 설명서 - 페이지 11

{카테고리_이름} ABB 6310408P에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB 6310408P 17 페이지. Maintenance bypass panel for 827e inverter plant

3: System Installation

NOTE: ABB POWER recommends that the Maintenance Bypass Panel is installed above the top-most

827E Inverter Shelf (refer to Figure 3-1). ABB POWER recommends leaving one rack mounting space

between the MBS and the first Inverter shelf as well as from Inverter shelf to inverter shelf to allow air

flow between units for proper heat dissipation (refer to Figure 3-1).

CABLING:

A. Remove the maintenance bypass panel from the shipping container.

B. Install the panel as follows:

1. Ensure there is proper clearance in the rack to install the maintenance bypass panel.

2. Put the panel into position and secure with the screws located at each outside corner (four screws total).

NOTE: The maintenance bypass panel is designed to be either flush or mid mounted.

Page 11

MAINTENANCE

BYPASS PANEL

FIGURE 3-1: TYPICAL MAINTENANCE BYPASS PANEL INSTALLATION

827E MBS_MAN

Rev. 2.4