ENSOTECH SWAVE-E2 사용자 설명서 - 페이지 4

{카테고리_이름} ENSOTECH SWAVE-E2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ENSOTECH SWAVE-E2 11 페이지. Electronic speed controller
ENSOTECH SWAVE-E2에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지)

페이지 인쇄

HARDWARE IS YOUR EXCELLENCE

SOLDERING THE CABLE

-DO NOT OVERHEAT SOLDER TABS, consider of small size electronics components are very sensitive and easy to

damage by over heat, Ensotech recommend it should not soldering each connection point more than 1 second with

maximum of 300 degree Celsius. Beside, please make sure the cable and soldering material are well covered the

conductive surfaces as possible, and fully isolated from any other conductive surfaces.

If weak connecting of conductive surfaces cause the ESC failure, it is not under warranty.

Better soldering work gives advantage of decrease the electronic resistance, the calibration beep sound become

launder and the ESC will perform better performance.

HOOKUP INSTRUCTION

Connect "sensor cable" – a cable between ESC and Ensotech certified sensored motors.

Connect "receiver cable" – a cable between ESC and receiver. We have included two different types of cable plug (JR

& JST) for different receivers.

The motor should be well and properly soldered to the ESC. This is very valuable for getting full performance from the

system and reduce heating.

MTR

Swave E2/W

Connection

Diagram

WWW.ENSOTECH.LTD

Unit F, 6 Floor, Cheung Hing Shing Centre, No.23, Sha Tsui Road, Tsuen Wan,

Battery

New Territories, Hong Kong

Hall

Throttle

Uart

Android

Link

Receiver

Smartphone