Dell Dimension 2400 Series 매뉴얼 - 페이지 10

{카테고리_이름} Dell Dimension 2400 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Dimension 2400 Series 43 페이지. Vga card installation instructions
Dell Dimension 2400 Series에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (2 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (8 페이지), 랙 설치 지침 (32 페이지), 설치 지침 (1 페이지)

페이지 인쇄

Back to Contents Page

Drives

Dell™ Dimension™ 2400 Series

Adding a Floppy Drive

Adding or Replacing a CD or DVD Drive

Replacing a Hard Drive

Adding a Floppy Drive

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual or Product Information

Guide.

Shut down the computer

through the Start menu.

2. Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut

down your computer, turn them off now.

NOTICE:

To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.

3. Disconnect any telephone or telecommunication lines from the computer.

4. Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.

CAUTION:

To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

Remove the computer

cover.

Release and remove the front

Remove the front-panel

insert.

8. Connect the floppy-drive power cable to the back of the drive.

CAUTION:

Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").

9. Connect the data cable to the back of the drive and to the floppy drive connector on the

10. Position the top of the floppy drive bracket so that it is completely flush with the bottom of the lower drive bay, and then slide the floppy drive bracket

forward into place.

NOTE:

The top of the floppy drive bracket has two slots that fit into two clips on the bottom of the upper drive bay. When the floppy drive bracket is

properly mounted, it remains in place without support.

11. Secure the floppy drive bracket with the top bracket screw that came with your drive.

12.

Reattach the front

panel.

system

board.