Dell Dimension 4700C 서비스 매뉴얼 - 페이지 22

{카테고리_이름} Dell Dimension 4700C에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Dimension 4700C 42 페이지. Dell desktop computer quick setup guide
Dell Dimension 4700C에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지)

페이지 인쇄

Remove the computer

stand, if it is attached.

CAUTION:

To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

NOTICE:

Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the

computer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.

7. Disconnect the AC power cable from the power supply connector.

Open the computer

cover.

9. Disconnect the DC power cables from the system board and the drives.

Note the routing of the DC power cables underneath the tabs in the computer frame as you remove them from the system board and drives. You must

route these cables properly when you replace them to prevent their being pinched or crimped.

10. Press the release button located on the floor of the computer frame.

11. Slide the power supply approximately 1 inch toward the front of the computer.

12. Lift the power supply up and out of the computer.

Replacing the Power Supply

1. Slide the power supply into place.

2. Run the cables underneath the clips, and press the clips to close them over the cables.

3. Reconnect the DC power cables

Close the computer

cover.

5. Connect the AC power cable to the power supply connector.

Attach the computer stand

(optional).

NOTICE:

To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

7. Connect your computer and devices to electrical outlets, and turn them on.

System Board