Allied Telesis Rapier i series 문제 해결 - 페이지 2
{카테고리_이름} Allied Telesis Rapier i series에 대한 문제 해결을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis Rapier i series 5 페이지. Virtual router redundancy protocol
Allied Telesis Rapier i series에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (8 페이지), 구성 방법 (9 페이지)
페이지 인쇄
Starting off
When going on-site to investigate a network problem, your guiding aim is to understand the
root cause of the problem, which might be:
Of course, it might not always be possible to find the root cause, but looking for it should be
the central target of your debugging session.
However, it is also important to make sure that you are also capturing enough information
(and the right sort of information) to enable someone else to effectively analyse what you
have captured. This could be so that they can confirm your theory about the root cause of
the problem, or, in the case that you were not able to nail down the root cause, so that they
can develop their own theories about what the cause might be.
Concrete piece of advice #1: Capture everything
Right from the first moment you attach your terminal emulator to the console port of the
first piece of equipment, ensure that the logging facility of the terminal emulator is turned on.
This means that you will capture a lot of (seemingly) irrelevant stuff, but it also means that
you will not fail to capture the important stuff.
Concrete piece of advice #2: Capture the initial state
It is important to approach the problem with an open mind, and start with a general survey
of the equipment you are looking at, to give an initial picture of how things were at the start
of debugging session. This might be the "network operating OK" state, or the "things going
wrong" state, depending on what state the network was in when you arrived.
In this initial survey, you should capture a show debug from every relevant unit, and capture
all the counters and module states that are relevant to the issue.
For example, if the network consists of switches, and the problem is related to PIM multicast
routing, then you will want to capture the following commands:
2
a cable plugged into the wrong socket
a misconfiguration of some piece of equipment
an interoperability problem between two pieces of equipment
a hardware fault in some piece of equipment
a bug in the software of some piece of equipment.
show switch count
show switch port=all
show switch port=all count
show ip route
show ip route multi
show ip igmp