DH Instruments PPC 설치 지침

{카테고리_이름} DH Instruments PPC에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DH Instruments PPC 1 페이지. Communications software
DH Instruments PPC에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)

페이지 인쇄

RACK MOUNT KIT, P/N 400440, INCLUDES

FIGURE

QTY

PART NO

CALLOUT

123698

123700

100972-Z

102668-Z

100918-Z

123702

123765

INSTALLATION INSTRUCTIONS

Place one side bracket (2) on each side of the PPC™.

Position

each

bracket

attachment flange (flange with three holes) facing

the front of the PPC.

Attach the front panel (1) to the side brackets (2)

using six M4 flat washers (5), six M4 split

lock washers (4) and six M4 hex nuts (3).

Recommended torque is 3 Nm.

Remove adhesive backing from foam strip (7).

Adhere the foam strip to the rear support bracket

(6), centering the foam as shown in figure 2.

Attach the rear support bracket (6) to the side

brackets (2) using four M4 flat washers (5), four

M4 split lock washers (4) and four M4 hex nuts

(3). Recommended torque is 3 Nm.

For adequate support of the PPC, the rear support

bracket (6) shall be supported on the side rails of

the rack system or by other means.

Document 560030c

DH Instruments, Inc.

4765 East Beautiful Lane

Phoenix AZ 85044-5318

USA

DESCRIPTION

Front panel

Side bracket

M4 hex nut

M4 split lock washer

M4 flat washer

Rear support bracket

Foam gasket

with

the

front

panel

PPC is a trademark, registered and otherwise, of DH Instruments, Inc.

PPC™

Rack Mount Kit

P/N 400440

Installation Instructions

Figure 1 Rack Mount Kit

Figure 2 Rear Support Bracket and Foam

031117

Tel 602.431.9100

Fax 602.431.9559

[email protected]