Allied Telesis AR400 Series 방법 - 페이지 3

{카테고리_이름} Allied Telesis AR400 Series에 대한 방법을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AR400 Series 8 페이지. How to set up pppoe between a linux client and access concentrator
Allied Telesis AR400 Series에 대해서도 마찬가지입니다: 구성 방법 (6 페이지), 문제 해결 매뉴얼 (8 페이지), 문제 해결 (5 페이지), 빠른 설치 매뉴얼 (8 페이지), 빠른 설치 매뉴얼 (12 페이지), 안전 정보 매뉴얼 (18 페이지)

페이지 인쇄
Allied Telesis AR400 Series 방법
Configuring Your Linux Device
!
1. Set a host name. The host name must be a user on the Allied Telesis device. To set a default
hostname on your linux device, use "hostname <newname>":
[root@linux_client michael]# hostname
linux_client
2. Check the ppp options file. The options file is not used when this particular pppd link is started.
However, if it is used, it should look like this:
[root@linux_client michael]# cat /etc/ppp/options
lock
#debug
#novj
#require-pap
3. Check the CHAP secrets file. In this configuration there are a number of lines that are
commented out but only the last line is used. The last line of your CHAP secrets file should look
like this (as underlined in output below):
[root@linux_client michael]# cat /etc/ppp/chap-secrets
# Secrets for authentication using CHAP
# client
#
#*
#tester
#*
#eightbit
#manager
linux_client
Set Up PPPoE Between a Linux Client and an Allied Telesis Access Concentrator
Configure your Linux device as follows:
server
test
*
*
*
pptpd
*
secret
IP addresses
password
*
12345678
1.1.1.1
eightbit
*
eightbit
1.1.1.2
friend
*
password
*
3