Allied Telesis AR450S 빠른 설치 매뉴얼 - 페이지 5

{카테고리_이름} Allied Telesis AR450S에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AR450S 12 페이지. Ar400 series
Allied Telesis AR450S에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (12 페이지)

페이지 인쇄
Allied Telesis AR450S 빠른 설치 매뉴얼
Quick Install Guide
Figure 1: Front and rear panels of an AR450S, showing the AC power inlet, power switch, console ports and
Ethernet ports, and their associated LEDs.
C613-04045-01 REV A
5.
Apply power to the router.
Fit the power cord retaining clip to the AC power inlet on the router's rear
panel.
Connect the provided power cord to the AC power inlet and clip it in
place. Switch the router's power switch to the ON position. The Power
LED will light continuously and the System LED will flash briefly. The Port
LEDs may also light briefly.
If the LEDs fail to light, the most likely cause is that the router is not
receiving power. Check that
•
The power supply outlet's switch (if any), and the router's power
switch, are in the ON position
•
The power cable is securely plugged in
•
The power supply is operational
If the LEDs light incorrectly, refer to the AR Router Hardware Reference for
troubleshooting information.

Configuring the Router

AR450S routers can be configured via the Command Line Interface (CLI) or
Graphical User Interface (GUI).
Using the CLI to configure a router:
1.
Initiate router start-up.
Using the terminal cable supplied, connect a VT100-compatible terminal,
or the COM port of a PC running a terminal emulation program such as
Windows Terminal, to the Console RS-232 (ASYN0) port on the router's
rear panel.
5